Whirlpool Duet Dryer Won't Start. This mechanism keeps the door locked while the dryer runs. Always check that the dryer is receiving the proper amount of 240v current.
If the dryer is not level, the sensing does not work properly, and your drying cycle will end early. Whirlpool duet dryer won't start a cycle check the circuits. It is not likely the belt broke but the thermal fuse is certainly a possibility and i am including in the images below how to access and check the thermal fuse on most whirlpool duet dryers.
One Of The Common Problems With A Whirlpool Is That The Dryer Simply Won't Start.
It also stops it if the door is opened during a drying cycle. If your dryer just clicks and will not start, a blown thermal fuse is often the problem. On the control panel of the whirlpool duet dryer, and similar dryers, you push both a power button and an actual start button to use the dryer.
It May Just Need To Be Cleaned To Remove Lint And Residue.
The most prominent cause of this issue is a defective door latch assembly. You can fix the above six common causes of a whirlpool duet dryer that won’t start, following these simple steps for each problem. You would need to take off the lower front access panel under your door, then take off the duct assembly#45, by removing the two #11 screws as shown in your parts diagram here:
Without A Meter Is Is Difficult To Determine Why The Dryer Will Not Start.
If the dryer is not level, the sensing does not work properly, and your drying cycle will end early. Whirlpool duet dryer won't start just clicks. Hi, ok, lets first check your thermal fuse.
Bulkhead Parts For Whirlpool Gew9250Pw1.
This video will show you what you need to check if you press the start button on your kenmore or whirlpool dryer and it does not start up. So, if your gew9250pw0 dryer does not start when the door is closed, not starting or won't turn on, the following info will help you identify the problem. The whirlpool dryer won’t start but has power if you see that your whirlpool dryer has power but won’t start, it might be an issue with your dryer door switch.
All The Lights Come On But When I Press 'Start', All I Get Is A Click.
Power not reaching the dryer. The door switch seems to work fine, in that it will turn out the light. Most whirlpool dryer parts are stocked by appliance stores, so you don't have to worry about a part going on back order.